OVEN ELEMENT FAN FORCED

"1 remove the fan cover from the inside of the oven to expose the element four phillips head screws. 2 withdraw the oven from its cabinet two phillips head screws. 3 remove back cover five phillips head screws. 4 disconnect the wiring from the element and peel back the insulation from around it. 5 undo two nuts securing the element and remove it from the inside of the oven. 6 installation procedure for the new element is the reverse."

"Turn electrical supply off to oven. remove oven from fitting area screws located behind rubber door seal. remove back steel sheet locate nuts holding old element in place remove. pull wire connections from all 3 points remove element from inside oven and replace with new element. replace wires and nuts. note the screws on our oven were a star design not straight philips head but a small philips head sufficed to remove and replace them."

"Disconnect the power. pull the oven from the wall. remove the back cover, then remove the mounting screws and disconnect the old elemnet. fit the new element reconnect the wires and fit the rear cover. replace the oven and turn the power back on."

"Disconnect electricity supply. remove oven from cabinet. remove fan cover from inside oven. remove rear oven cover. remove electrical connections from element. remove element securing screws at rear and front and remove element. install new element."

"Got to have the part to fit it"

"Needed to remove the oven from the wall and connect the wiring terminals from the rear of the oven."

"Didnt fit incorrect part"

"The element received was not a direct replacement for the to400x. required a plate to be made to cover the fitment hole in the oven. otherwise there would be an open hole into the back of the oven."

"You have to take the oven completely out and take the back cover off. there is another cover you need to remove to get to the nuts that hold the element in."

"Simple job - power off before starting."