"They were filter baskets....no fitting required"
ONE CUP SINGLE WALL FILTER
Location Ref: 01.28
Exploded diagrams, Schematics and other documents
Installation
Jeremy
WELLINGTON
"Unscrew top and 2 back panels. locate top of old steam wand. unscrew. cut wires entering wand. follow water tube to end, disconnect by pulling out metal tab then sliding out the tube. pull the old wand up and out which took some jiggling. slide new wand into place and screw in. push new water tube in and clip in, tube needs to be deep enough that clip goes over the tube plastic. for the green earth wire unscrew where all earth wires meet, unclip wire from 2 other locations and replace with new wire. screwing them all back is fiddly. for the red and white wires pull out the old write from where it was cut, hand pass the new one along. i had to replace some of the cable ties. you will need to unscrew the white box at the back in order to plug the white and red cables in. for the final wires i would suggest just joining to the old wire where cut using a one time connector as they are already connected this way further along."
George
NSW
"Replace"
Bruce
NSW
"Remove old clip from filter handle and fit new cup - made a very tight fit. to replace group head seal, remove central screw and remove shower screen and seal (clean them), replace seal and screen and screw back up."