"It was very easy to fit the part."
SILICONE WASHER
Location Ref:
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Leslie
QLD
"Unscrew phillips head screw, replace ring."
Rick
VIC
"Remove steam wand using shifter if necessary, remove the worn-broken seals and washer replace in same order and fit steam wand back. do not over tighten."
Kingsley
VIC
"Replaced washer and seals"
David
QLD
"Unscrew the nut holding the steam pipe and replace the broken seals. no problems - both seals were cracked"
Jean-baptiste
ACT
"Just replace the washer."
Mike
QLD
"Using the exploded diagram on this site loosen the nut with a spanner to remove wand. then remove rubber handle from wand and push it back through the nut and remove washers and seal. replace with new parts then put back together."
Lindsay
ACT
"Undo the the seal nut and remove exposing the two seal washers and the flat washer and assemble in the reverse order."
Angela
QLD
"Ive had my machine for 6 years and this is the first time i have had to do any maintenance other than the usual cleaning. my silicone seals were cracked and very brown and the washer was very flat. the hard part was finding a supplier for the parts. so glad i did. just remove the steam wand remove the hexagonal head and slide the rubber grip off and the nut down. this allows the bottom seal to be set in place before replacing the nut. put the rubber grip back on and the hexagonal head. insert the top silicone seal and the washer . re attach the wand to the machine. run some steam through to ensure the seal is adequate do not over tighten."
Simon
VIC
"Just unscrew nut, remove old seal, remove rubber gri handle, install new parts and screw back together"
