"Wet the rubber with very thin film of olive oil"
STEAM WAND HANDLE
Location Ref:
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Anthony
VIC
"The old one didnt seem to want to slide off easily so i cut it off. i then wet the new one to make it easier for it to slide on."
Sian
WA
"Remove old wand handle rubber. heat new rubber and slide on."
Ray
VIC
"Remove old rubber using a sharp knife cutting lightly into the rubber being careful not to score the stainless steel steam wand. peel the old rubber away. clean the wand using a scouring pad and water then wipe dry. being careful to have the new rubber the right way around push the preformed rubber onto the wand. work the rubber onto the wand by partially rotating back and forth as you push upwards. push the rubber up to the point of the natural bend in the steam wand pipe."
Kath
VIC
"Slid on"
Marijan
VIC
"By hand"
Mark
QLD
"Xxxxxxxxx"
Steve
NSW
"Remove the steam wand sleeve, immerse rubber handle in hot water to soften, slide off. similarly warm the replacement and slide into position. reattach steam wand sleeve."
Kelly
QLD
"Push handle onto wand"
Anthony
VIC
"Pull off the old one. heat up new one in hot water then slip it on."
