"Remove top of machine, remove probes and change."
O-RING FOR ELBOW TUBE
Location Ref: 1.2
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Richard
VIC
"When the part arrives ill tell you. at this stage i dont even know if its the right deal as your info on the website is not very clear."
Steve
NSW
"Perfect"
Ronald
NSW
"Remove the screws (x2) on the back of the machine - located at the top lh and rh corner. remove the screws (x2) located on the underside of next to the grinder outlet and the group head - this has been the worst bit. remove the top be careful of the earth lead. located the leaking hose and remove the clips (x2), remove hose, remove o-rings and install new o-rings, install hose - push down on one end and insert clip - do the same on other end, install screws in reverse of removal good to go."
Marc
VIC
"Hard plastic elbow discoloured from heat propably small hole. replaced. hard to remove, have to remove base plate holding part 2 screws. then remove connectors for tubes and elbows. small o rings, dont lose"
Martin
MONTRAL NORD
"Replacement hose was a perfect fit along with o-rins and clips"
