O-RING (ORANGE) FOR STEAM WAND HEAD SITS BELOW THE WHITE HEAT IS

"Unscrew tip of wand"

"Easy fix. take out the water tank. turn unit upside down on your work bench. use allen key to remove the shower screen. use small screw driver to carefully remove the dark brown plastic disc and the white seal. clean all exposed areas and reassemble."

"- unscrew steamer wand tip - remove old broken gasket - install new gasket - screw wand tip back on"

"Fitment is quite straightforward as sliding on parts."

"Easy to fit"

"Perfect fit"

"Unscrew top and 2 back panels. locate top of old steam wand. unscrew. cut wires entering wand. follow water tube to end, disconnect by pulling out metal tab then sliding out the tube. pull the old wand up and out which took some jiggling. slide new wand into place and screw in. push new water tube in and clip in, tube needs to be deep enough that clip goes over the tube plastic. for the green earth wire unscrew where all earth wires meet, unclip wire from 2 other locations and replace with new wire. screwing them all back is fiddly. for the red and white wires pull out the old write from where it was cut, hand pass the new one along. i had to replace some of the cable ties. you will need to unscrew the white box at the back in order to plug the white and red cables in. for the final wires i would suggest just joining to the old wire where cut using a one time connector as they are already connected this way further along."

"Fits perfectly"

"Open back and top of the machine, loosened all screws - note they seem to try and use a different screw on every possible place so dont just dump them all into a big pile. then traced all the wires and as i removed the old wands wire plugged or soldered the new on. insulated the solder joints with shrink tube removed the old wand and put the new one in. zip tied all the ones i remove again and closed it up."

"Na"