"Really good explanation. no probems at all"
PROPANE (LPG) CONVERSION KIT (INC WOK INJECTOR)
Location Ref: Page: 10
Exploded diagrams, Schematics and other documents
Installation
Dennis
QLD
"Remove the gas control knobs, the panel behind the gas knobs held in by a screw on either side can be accessed when the grill door is open. change out the old jets by 6 for the new jets as per the sheet supplied for jet sizes. four jets are located under the the top of the burners on the stove top. the grill jet is located in the center of the grillup top of the grill door opening. change out the old orifice plate on the grill for the new one suppliedlocated in front of the grill gas jet held in by two pk screws - a thinshort shafted screwdriver is required to slide up the small hole under the orifice plate to access the screws. the oven jet is located behind the rear panel of the stove at the bottom. remove the stove rear panelheld by pk screws, remove the lower heat shield - this piece of tin plate just sits in place - a section of the gas manifold has to be removed to fit the oven jet this slides in out is held by a pk screw.remove the old bypass screw in the oven control knob replace with the new one supplied.remove the natural gas regulator on the gas inlet pipe fit the new gas brass socketnoting the flow direction arrow.fit the lpg sticker over the top of the natural gas sticker. connect lpg to the stove using the correct low pressure regulatorlpg gas bottle and regulator used on most gas bbqs. ensure all gas knobs are turned off on the stove.turn on the gas light one burner on a low flame settingadjust the bypass screw for that burner until a stable flame is achievedand then try the burner on highwhen happy with the lowhigh flame repeat on the remaining burnersgrill oven"
Ioan
SA
"Very easy.........for how know"
Chris
VIC
"Should be done by registered plumber"
Paul
VIC
"The gas fitter installed"
Peter
SA
"Follow instructions provided."
Trevor
NSW
"Follow instruction sheet which says it all"
Don
NSW
"Very straightforward - remove and replace procedure as per instructions supplied"
Loraine
SA
"The part hasnt been used yet but i am reassured it was the right item and will do the job nicely"
Jj
SA
"Easy to follow instructions"