Grinding burrs pair turn direction right D1 ø 58mm ID ø 33,4mm H 8,5mm tooth spacing 3mm hole ø 5mm
Location Ref: Pg:5 Item:
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Turn direction
right
Diameter 1
58 mm
Internal diameter
33,4 mm
Height
8,5 mm
Tooth spacing
3 mm
Hole diameter
5 mm
Bore diameter
8,5 mm
Mounting diameter
44
Suitable for
K3
Installation
Thomas
THURGOONA
"Parts fit well coffee grinder is works again. thanks"
Roman
ALEXANDRIA
"Done intuitively. there are instructions videos online. it was a bit tough to extract the old valve gaskets due to their age and i used dremel with a small drilling bit to break the old gaskets into pieces and then to extract them piece by piece"
Brenton
SOUTH AUSTRALIA
"Easy replacement"
David
NSW
"Remove the top adjustment. remove the 3 screws holding blade to the top holder. remove the 3 screws holding the bottom blade in position. clean out the chamber of as much of the old coffee and possibly. put new blade in and screw back in dont over tighten as can cause issue the next time need to replace. put top blade holder back in and screw down until blades touch then back off half a turn and than can start calibrating the grinder."
Our outstanding service has lead to an average customer rating of 4.5/5.
Great service. Recommend.
Fast postage and great communication. Was always keep up to date regarding the status of my order
Very happy with service.
Prompt service satisfied customer.
Great service. Prompt delivery.
Great service. Prompt delivery.
Great service. Prompt delivery.
Good selection and service.
Hard to fault communication was good and consistently gave upgrades at where the parcel was at all times. Parcel arrived about the time I anticipated. Thanks very much.
Good information on the site easy to navigate. The part was in stock shipped promptly and arrived within the expected time. Job well done thank you.
Very easy to deal with, found the part I needed and it was shipped as described.