"2 screws to remove the top cover, then lift out the roller brush. put the belt over the brush then over the drive pin. the belt is fairly small so has to be stretched a long way then slide the brush bearings down into their pockets. replace the top cover."
BELT (ORIGINAL)
Location Ref:
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Stuart
QLD
"Remove plastic cowl by removing two phillips screws, replace belt and refit cowl."
Gary
WA
"Remove 3 screws on vac head coverremove old brush and belt. put belt on motor pulley and then onto new brushpull to front of vac head and brush will clip down onto holder. place cover back on and screw back on"
Harry
QLD
"Remove the two phillips head screws from the front of the plastic cover in front of the vacuum cleaner. remove the plastic cover. remove the old belt on the right hand side. place new belt on the spindle then on the roller brush stretch the roller brush back into position and replace plastic cover."
Halina
NSW
"Easily replaced"
Russell
NSW
"Remove two phillips head screws from top cover, pull cover up to remove and expose belt. pull on brush, slip belt over top thin shaft, slide brush through belt and pull into position replace cover and screws"
Graeme
VIC
"Remove 3 screws on cover plate cover plate"