"Remove phillips head screws from under floor tool and swing back the bottom section. remove the damaged brush nozzle. remove the two screws securing the small motor. remove and replace the damaged belt. refit the motor and replace the new brush nozzle. rehinge the bottom section tightening up the phillips head screws."
BRUSH NOZZLE
Location Ref:
Exploded diagrams, Schematics and other documents
Installation
Arthur
QLD
"Loosen motor 2 screws., remove old belt. fit new and re-tighten screws."
Warwick
NSW
"Remove head - remove 6 torx screws - lift off top cover without pulling two cables inside - unplug cables - gently move plasic tab at motor end - even more carefully use flat screwdriver to ease motor housing towards end of head while easing up plastic tongue in groove immediately adjacent motor on top surface - roll motor upwards and forwards to disengage it from head housing. repace belt carefully reassemble in reverse order."
Ashley
SA
"Open the brush, roll cover by operating latches and pull out broken brush roll. insert the new brush roll and refit in reverse order."
Tim
NSW
"Basically remove the screws and carefully prise the head apart"
Ivan
QLD
"Open cover and replace"
Lesley
NEW ZEALAND
"The part that has finally arrived today is too big. so has actually been an expensive exercise"