"Electrical connector attaches easily and sensor simply sits between coil fins"
Heath
QLD
"Remove the screw in the front of the bottom plastic cover and remove cover. remove the 2 screws in the back cover and remove the cover. the thermostat is located high on the right and is held in place by a cable tie and has 2 spade connectors. the new thermostat has a plastic plug and has to be replaced by the spade connectors."
Vic
NT
"Remove the 2 screws at the top of the plastic cover at the rear of the freezer compartment. this will expose the cooling components. locate the thermostat at the top right of the cooling fins. the thermostat has red and pink wiring. unclip the electrical connection and gently pull out the thermostat from within the fins. install the new thermostat and reinstall plastic cover. its an easy fix."
Our outstanding service has lead to an average customer rating of 4.5/5.
Great service. Recommend.
Fast postage and great communication. Was always keep up to date regarding the status of my order
Very happy with service.
Prompt service satisfied customer.
Great service. Prompt delivery.
Great service. Prompt delivery.
Great service. Prompt delivery.
Good selection and service.
Hard to fault communication was good and consistently gave upgrades at where the parcel was at all times. Parcel arrived about the time I anticipated. Thanks very much.
Good information on the site easy to navigate. The part was in stock shipped promptly and arrived within the expected time. Job well done thank you.
Very easy to deal with, found the part I needed and it was shipped as described.