"Remove panel, disconnect device, replace and fit back panel"
HANDLE ASSY
Location Ref: Page: 6
Exploded diagrams, Schematics and other documents
Installation
Geoff
QLD
"Door latch broken on dishwasher not allowing washer to operate electrically. see following repair process after door latch and limit switch assembly arrived 1.turn off power and remove plug from wall socket 2.open dishwasher door and remove 10 or so screws holding door together so that the electrical switch and latch assembly can be accessed 3.ensure no power by testing for dead with an electrical multimeter or volt tester 4.disconnect 2 connecting wires to door switch 5.remove latchswitch assembly 6.reattach 2 wires to door limit switch 7.reassemble door cover and reinstall screws. 8.reinsert electric plug and hey presto it worked."
David
QLD
"Should have been very simple. two screws however part was not assembled properly"
Kelly
VIC
"Job still not finished after following others instructions"
Ruiel
VIC
"Switch off power point. open and remove all screws off door inner panel first. separate the front and inner panels partially just enough to get access to the door latch. caution - the panel edge is very sharp. remove two screws and disconnect wires. ensure latch is on open position to insert switch - pry if needed. connect latch wires and screw in position. screw the inner panel then close the door. if the door is not closing the latch might be in closed position."
Diana
NSW
"No tip"