"Turn dishwasher upside down. remover plastic cover from bottom. remover element wires and earth remover 3 phillips heat screws. ease element from housing. remove or in seal from old element and install on new. install in reverse order"
HEATING ELEMENTS ASSEMBLY
Location Ref: Page: 3
Exploded diagrams, Schematics and other documents
Installation
Loan
NSW
"Turn off power switch and unplug from power point. turn off water connection and drain water into a container. pull out dish racks and set aside. our dishwasher was not screwed to the bench as it is a stone bench. if it is screwed to the bench unscrew it. have an old towel to mop up any water spills when dishwasher is turned onto side. the heat element is located under the dishwasher. unscrew using a flat head screw driver. replace heat element making note of which wire is connected to which part. tighten screws on and wires. place the dish washer back as it was. ours worked right away. i used the diagram (that bigwarehouse provided on the website for the part) to locate the heat element."
Jason
NSW
"Simple diy job. turn the dishwasher on its side with the heating element facing up so when you remove it from its housing water does not spill out. there are three electrical connections to unplug on the heating element and three screws to undo. transfer the gasket from the old heating element to the replacment and reverse the above procedure."
Frank
QLD
"As per instructions by others"
Colin
QLD
"I used your spare parts diagrams to see where the element was located, then i accessed it and replaced it"
George
NSW
"Tip upside down, unclip cover. you will see 3 wires going to element with 3 phillips head screws."