"Part just clips in"
DOOR SEAL
Location Ref: Page: 3
Exploded diagrams, Schematics and other documents
Installation
Shane
QLD
"Simply take old off and put new one on."
Brian
SA
"Fits in with metal clips."
Terry
QLD
"Oven door started to fall open and the seal fell out and the light stopped working follow advice specific to smeg on youtube"
Peter
SA
"Self explanatory"
Susan
NSW
"Hooks into place"
Ben
VIC
"Just clips in"
Ric
NSW
"Use the standard door removal procedure to give better access to the front of the oven opening and seal. remove the old seal by pulling the retaining clips in each corner out of the front of the oven opening surround and then the last clip at the top centre of the seal. remember which holes the original clips came out from as there are numerous holes in the front surround panel. orientate the new seal correctly with the fifth clip at the centre top position hole and the joint in the seal at the bottom centre position. then stretch the top left and right corners to locate and fit the clips into their original holes. now stretch and locate the bottom left and right corner clips to their original holes. finally check that all the clips are fitted securely into their holes and the seal is seated flush against the front surround panel and not twisted. refit the oven door and check the final fit of the seal."
Justin
QLD
"When listing such parts as oven door seals - it is suggested you quote the dimensions of the oven door. this will make the customers choice of replacement seal easier."
George
NSW
"Simple fit"