"Isolate power, take back off oven, replace part, reassemble."
PCB
Location Ref: Page: 2
Exploded diagrams, Schematics and other documents
Installation
Jeff
QLD
"Isolate the power, remove rear panel, removed relay card, mounted new relay card transferred each wire 1 at a time, tested to see if working, replaced rear panel, tested again for elements heating up and fans running."
Barry
VIC
"Spade connector insulating covers may be brittle due to heating, handle with care or have some new ones on hand to replace any broken ones"
Adam
NT
"Replace pcb in rear of oven"
Rod
QLD
"Remove back panel and replace part, reassembled and tested ok."
John
NSW
"Pcb board circuit track blown to one relay."
Thomas
QLD
"Removed back panel, found old pcb and removed from mount (left spade bits connected). had to drill new holes for clips as the new pcb was smaller. mounted new pcb and connected spade bits one by one in same positions. removed oven top (is tricky you need to remove the screws on each burner). found old thermostat and removed. cable runs to back of oven and thermostat goes into clips inside oven. mounted new one and reassembled covers."
Mark
VIC
"Remove rear cover front panel and top to access parts for replacement, fit new parts test and reassemble."