FF ELEMENT

"Once oven taken out remove the back cover. disconnect the main power supply wires (live neutral and earth) located in the bottom left hand side corner of the back cover (take a picture or note down the position of the wires). disconnect the wires from the element (two wires - take a picture or note down the position of the wires). remove the fan cover (two screws) inside the oven. remove the element (3 screws). fit the new element and put screws back (3). fit the fan cover back (2 screws). connect the element wires (2). connect the main power supply wires (3). fit the back cover back. put the oven back (dont forget to plug it first). and you are done. happy baking."

"Take back off stove and replace element"

"Tip is to use youtube"

"Remove oven from joinery. remove backplate. remove element cover from inside of oven. unscrew existing element and remove after disconnecting power terminals. screw in new element connect power terminals and reinstall element cover. refix backplate of over and refix into joinery."

"Simple. cut power to oven at mains. remove fan cover at back of oven, remove element and replace, make sure wires are extended far enough not to withdraw through holes."

"Hubby did it"

"Still trying to fit it because we are still waiting on you to send the correct part"

"By hand"

"My husband fitted it so i can not order advice for sitting part."

"Access-fitting is both from the front and the rear of the oven so pull it out of the wall first and place on a table to allow easy access. this will save time trying to work out how to do the replacement, from there all you need is a phillips head and a flat head screwdriver and a pair of pliers. note the new replacement element does not have an earth lug on it so just place the loose earth lead (from the old element) to the fan chassis (or any other part of the outside of the oven - or you can just tape up and secure as there are several earth points connected on the oven so it is well protected."