"Replace old with new."
LIGHT DIFFUSER
Location Ref: Page: 2
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Megan
NSW
"Easy to replace just dont do the screw up too tight"
Stephen
QLD
"Wrong part"
Glen
ACT
"Replace"
Joanne
NSW
"Line up with the holes, put the screws back in."
Rob
ACT
"Remove the broken light cover by unscrewing the one screw that holds it in place, then slide the light cover to the right and it will drop out of the rangehood. give the rangehood and light fitting a good clean. install the replacement light cover by fitting the prongs on the left end of light cover in to the rangehood. slide the light cover to the left until firmly in place and hold it in place while you insert the single screw and tighten it."
Melinda
NSW
"Very simple to install it just needed one screw."
Shirley
QLD
"Yousmeg supplied wrong part and then expected me to pay for return postage. you have made it too hard. i will take this up with smeg. the order has been cancelled. i will wait for your refund in full with postage refund. very disappointed."
Katrina
NSW
"Easy with screwdriver"
Annette
QLD
"Husband did it - easy job"
