""
FILTER ANTI-CALC CARTRIDGE 69/6910
Location Ref: 12
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Fiona
VIC
""
David
SA
""
David
SA
""
Mick
WA
"Popped the old one out popped the new in pretty simple."
Gavin
QLD
"Take out old one put in new one"
Jeremy
NSW
"I recommend not laying machine on its back. did this to try get leverage to undo screw but after putting new seal in reassembling standing machine upright, was concerned may have damaged as would not build sufficient pressure to operate. took a 3 minutes of running it to get it operating again. suspect may have just emptied the pipes or introduced air blockage. under all circumstances recommend removal of water tank before doing this. and always recommend disconnecting from mains power even though was nowhere near electrical circuits for replacement of this part."
Carl
SA
"Follow instructions"
Tony
QLD
"Replaced steam pump"
John
QLD
"Switch off machine. remove water compartment. remove rear door screw at bottom. remove rear plastic panel and side panel.remove pcb. remove and replace pump. work in reverse. takes 30 minutes. note leave the original mounting in place if still intact."
