"Remove cover swap over part"
Pressure control PRESSURE SWITCH XP110 125 0.5-1.5 BAR 1/
Location Ref: Pg:13 Item:005
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Philip
NSW
"Remove top of coffee machine when switched off and remove old pressure switch by undoing attached copper pipe from boiler. then detach pipe from old switch and reverse procedure."
Mick
VIC
"The coffee machine was actually an isomac tea ii. i chose these parts to be compatible. fitting was straightforward. but requires knowledge of electrical and pressure plumbing for coffee machines to be able to diagnose and then safely repair."
David
NSW
"2 17mm spanner to untighten. remove wires from old pressure stat switch and put on new pressure stat. retighten new pressure stat to the machine."
Shun
VICTORIA
"Remove and change"
Michael
NSW
"Easy change dont be afraid"
Tim
VICTORIA
"I fitted this to a expobar office control. remove the covers to get access to the pressurestat. use 2x 17mm open ended spanners to remove the old pressurestat. disconnect the 2 wires from the old unit. to fit the new part repeat above in reverse order."
Alister
VICTORIA
"This switch fits the expobar office lever as an original replacement part. two spanners to remove and replace and a flat blade screwdriver to adjust. bit of teflon tape over the threads to ensure a leakproof fit."
Chris
QLD
"Remove faulty and replace with this - easy job"
Abraham
NSW
"Easy to fit"
