"Remove old part and fit new one."
LAMP HOLDER
Location Ref: N.I.
Exploded diagrams, Schematics and other documents
Installation
Stephen
QLD
"Easy change over but remove the range hood from the wall"
Ian
WA
"Remove bottom screw, break lamp holder away from unit ( second screw not accessible ), fit new lampholder and fit bottom screw in, and thats it, ( cant fit top screw in not accessible to get to ) wire in to terminals"
Damian
WA
"Unscrew wires and screws for mounting"
Mark
WA
"1. turn off rangehood at mains. 2. remove filters 3. remove wiring of existing lamp unit and attach the wiring of the new lamp unit. 4. remove the exhaust housing. 5. unscrew old lamp unit from housing and install new lamp unit. 6. put exhaust housing back 7. and all should be working again )"
Stephen
WA
"Make sure power is isolated to range hood ( only a licenced person should carry out this work ), remove cover, disconnect the two wires and unscrew the lamp holder to remove. then screw in place the new part and reconnect the wires fit globes and turn power back on to test."
Norman
WA
"Non"
Jonathan
NSW
"Remove power. removed filters, remove 4x screws holding the internal fan unit. remove 4x screws from the front of the terminal block cover. remove 2x screws from lamp holder. disconnect the 2 wires (brown and grey). the install is the opposite. should take about 15 mins. quick and easy fix."