"Take the freezer shelf out, remove screws in back panel to access fan motor. put new one in then re-assemble."
MOTOR FAN 6.2 WATTS
Location Ref: 1A
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Foo
NSW
"The air is not flowing from the freezer to the fridge. open the freezer compartment and unscrew the 8 screws at the back cover and lift the panel out. pull the 3 cables off the fan and replace it with the new one. that simple. then put back the panel and all the screws. no wiring cutting required. only tool required is the phillip screw driver."
Andrew
QLD
"Remove back panel from freezer including the air diverter. discontect fan from spade terminals. dismantle bracket holding fan in place. note: if bolts rusted, spray with wd-40 and let stand overnight. refit in reverse order. note: remember or mark which way bracket and fan sat when mounted on back panel because if you place fan in upside down it will be foul of hole when you re-attach fan blade."
Thomas
QLD
"Remove back internal freezer wall and make sure fridge is unplugged from wall. remove fan brackets. remove fan and replace. put it all back together."
Mike
NSW
"Disconnect power, remove vent panel in freezer, 2 screws, remove fan by taking out bracket screws, 2 of, pull out gently and unplug spade connections, 2 of, undo all brackets, take fan blade off by pulling it off the shaft. refit all brackets and fan blade to the new motor and replace all covers"
Hong
VIC
"Replace motor fan"
Brian
VIC
"It was a plug in part"
Gregg
VIC
"Take rear cover from freezer, unscrew fan, disconnect cables, fit the new fan. hey presto it works"
