"Control board assembly is encased in a metal shroud secured by a single screw to the fridge body. care must be taken to squeeze the assembly past the compressor and wiring. wiring is simply removed by unplugging from board assembly and plugged into the new assembly. re install unit carefully past compressor and wiring harness an screw to fridge."
CONTROL BOARD/BOX ASSY. ERF2500
Location Ref: 1
Exploded diagrams, Schematics and other documents
Installation
Vincent
NSW
"Check with voltage meter if you have power coming to led display board - it will only be 1 or 2 volts - you will need a volt meter. if no voltage problem could be from control board."
Noni
WA
"Very easy"
John
QLD
"Get someone else to do it"
Philip
TAS
"Electrician"
Adriano
VIC
"I found getting the control board out difficult mainly because of where it was fitted and the mounting screw was on an angle so i needed to use a 14 drive extension with a universal joint adaptor and screw bit"
Christopher
NSW
"Access to the space to remove and replace is extremely tight."