"Remove back panel from freezer then disconnect the element remove the aluminium tires and replace element. very fiddley job."
Tony
SA
"Remove screws holding fan assembly rear panel and rear supports for shelf. remove parts carefully, when rear panel is laid flat unclip power wires and earth allowing it to be completely removed from the freezer. disconnect and remove ties holding old element (may be a single pass element). remove element. fix new double pass element centrally under coils being careful not to move coil assembly too much. fix element with ties. fit electrical connectors. use supplied long blue lead to get neutral from right side to left. tape wires to back wall ensuring it is clear of the coils and fan. refit back panel fan and shelf supports. fit earth wire to spade on fan body. brown and blue wires to motor coil.. if you have a multimeter check there is no continuity between active to earth and neutral to earth on highest ohm setting (e.g. 20m).. plug back into power point and check freezer fan runs freely."
Over 30,000 positive reviews
Our outstanding service has lead to an average customer rating of 4.5/5.
Great service. Recommend.
Fast postage and great communication. Was always keep up to date regarding the status of my order
Very happy with service.
Prompt service satisfied customer.
Great service. Prompt delivery.
Great service. Prompt delivery.
Great service. Prompt delivery.
Good selection and service.
Hard to fault communication was good and consistently gave upgrades at where the parcel was at all times. Parcel arrived about the time I anticipated. Thanks very much.
Good information on the site easy to navigate. The part was in stock shipped promptly and arrived within the expected time. Job well done thank you.
Very easy to deal with, found the part I needed and it was shipped as described.