"It was the wrong one but i made it fit"
DOOR HINGE CENTRE RIGHT- the door may need to be drilled out with an 11mm drill bit to suit the above part (original discontinued replacement supplied)
Location Ref:
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Steve
QLD
"Remove screws, put on new hinge, replace screws"
Rick
ACT
"Lot of effort to modify part to fit left side but works well"
Sandra
QLD
"Part not fitted as wrong part sent"
Mark
NSW
"Remove old one, fit new one"
Fred
NSW
"Need to drill out holes in doors to 11mm as explained in ad for part. also need to put a washer over the pin of the freezer door because the ramps around the hinge are different to the original hinge."
Anthony
VIC
"Easy to fit - just need appropriate socket and 5 minutes to do, additional pair of hands to lift fridge door would be of help but not necessary"
Eamon
VIC
"Was easy to fit - only issue was the door itself had been damaged and needed done epoxy glue to fill damage and hold thimble insert properly. took some time for glue to set before re-fitting door"
Michael
NSW
"The replacement hinge does not fit properly. i have had to insert more spacers to try to get the doors to close properly. even with 4 spacers the freezer door will not stay closed and we are holding it shut with an octopus strap"
Lois
NSW
"Hinge pretty straightforward although hinge part was too thick and needed to be grounded down for doors to shut."
