BAFFLE AIR, MOTORISED

"Remove the light cover from inside the fridge. remove the single phillips head screw. unclip the 3 -4 cable plugs and take the control panel out of the fridge. with a stanley knife cut the glue holding in the baffle. the baffle should slide out. be sure not to break the styrofoam housing. slide in the new baffle apply a silicon adhesive if you wish and reverse steps to re-install."

"Firstly remove power cord from socket, open fridge door, remove top self to allow you to access the digital display unit, remove light cover then bulb with a screwdriver, remove the screw then unit. unplug all the leads, this gives you access to the motorised baffle, replace complete part then reassemble in reverse, once that is complete plug in lead, the fridge will go back to default settings and all should be good....."

"Baffle was stuck fully open causing fridge to freeze. remove rear light lcd baffle assembly from fridge, disconnect plugs and replace."

"Faulty damper followed previous post in replacing"

"Take care to use the release tabs on the electrical connectors or you will break them and the foam rubber seal will need to be removed from the old one and fitted to the new one if you have not purchased that as an extra, it was fitted with double sided tape so care is needed when removing it."

"My husband is an electrician and took no time at all. took the light cover off and unscrewed the mechanism behind that which housed the baffle. would help if the rubber surround was sent with the part it is glued onto the original."

"Once i removed the old unit from the polystyrene molding i had to swap over the foam insulation around the baffle door."

"Temperature regulating vane (baffle) was sticking open . fridge is wse 6100. same part."

"After working out that it was the baffle was causing the fridge to freeze i found bigwarehouse sold and shipped the baffle. easy to fit now alls good. thanks bigwarehouse for sending shipping follow ups. cb."

"Removed cover panels from rear of fridge - disconnected broken motorised baffle and installed replacement"