"Use a butter knife to remove plastic base of runner to remove from fridge. using phillips head screwdriver for the screw, remove faulty stainless runner assembly and using butter knife release catch and remove from plastic base. replace runner assembly by sliding into position until runner locks into place. replace phillips screw and slide base back into position until clicks in place. lift basket into position and push down 8 to position on rubber ends. done )"
EXTENSION SLIDE ASSEMBLY (EACH)
Location Ref: 1
Exploded diagrams, Schematics and other documents
Installation
Amrat
VIC
"Replaced arm assembly in sliding rail since plastic was broken on original"
David
NSW
"Use the black locking clip to release broken part"
Andrew
NT
"The black inner clip release slides off, install new extension slider"
Richard
ACT
"Pull out slider, find small black plastic locking lever and push down. slider will then pull out"
Oisin
NSW
"The top freezer bin side assembly had broken. the assembly is made up of three parts, i had to remove one part as the existing piece in my freezer was ok and not required. removed the freezer bin and slide assembly onto the existing frame, attached the front panel to the bin and slide it back into place."
Chris
QLD
"Remove sliding module"
Meilinda
NSW
"Exchange the broken one with the new one."
Veronique
WA
"Take old part out and then fit new one in"