CONTROL BOARD ASSY (Use P/N 1596290)

"Turn off the power, unscrew the box, unplug and plug in the new board, then put it back in place"

"Remove back of fridge. unscrew control box with two screws, remove and replace. check you tube for further inx"

"Unplug fridge from wall remove metal cover plate from bottom of fridge remove control box from left hand side behind compressor only one screw( need short handle star screw driver) unplug leads from control boardnote which plug goes where plug new in new board place back in position"

"Need to fault find and identify fault, suggest min restricted electrical licence an advantage."

"Disconnect from power source, undo backing plat, undo philips head screw(one) from housing bottom left underside of control board, take out and replace with new replacement board, you will find that zd1 diode is burnt out, put back in reverse order"

"Power off, unscrew and unplug connection of the old part and reverse procedure to install the replacement part."

"Control board was located behind the fridge to the left hand side (bottom of fridge). to the left hand side of the compressor. unscrew it and pull it out of the back compartment. easily changed as terminals are pre connected. pull out terminations and replace with new control board. fix parts to origina position then turn on"

"Unsrew old cover and replace with new item"

"Easy to fit just plug and play. take photos before and after just to be sure if needed."

"Leave power off to fridge for at least 12hrs to ensure hv caps discharge. removed the back panel of the fridge (wse6100pa) then using a long or very short driver remove screw on right side of control box. then lift box up and to right to unhook tab. might require loosening or removing some things in the way to get the box out. then just swap over plugs."