"Remove lond handle from pedestals. unscrew pedestals from the door. screw in new pedestals attach new inserts and clip on long handle."
DOOR HANDLE INSERT (MOUNTING CLIP)
Location Ref:
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Amanda
NSW
"Had husband fit parts as needed specific small socket tool to undo bolts."
Ivan
WA
"Front panel must be removed to fit control panel side panels can be left on but pushed to the side to fit springs."
Helen
NSW
"Push handle upwards to remove from the door. use a socket driver to remove screws from broken mounting brackets and phillips head screwdriver to remove white door handle inserts if broken. replace with new brackets and inserts. re-screw and push handle downwards to re mount."
Mark
WA
"With the handle removed from brackets unscrew clips from the handle and replace with the new making sure that they are the correct way round so they click into the brackets. then reinsert handle into the brackets pulling down"
Jenny
QLD
"Slip handle up and take two srews out replace with new parts and slip handle back in to place."
Ross
NSW
"Very easy. move the handle in upwards and it becomes unattached. then undo 1 screw and replace the mounting bracket. replace the handle. two minute job!"
Daryl
QLD
"My handle had actually broken off - poor quality connections and only 2 yrs old so all fittings were exposed. make sure the fittings are screwed up very tight - i think this was the reason mine came loose and broke. to refit just push in and slide downwards with a little bit of force."
Rod
VIC
"Slide handle up - the handle will then come off the mounting brackets. refit the broken bits then place handle back on mounting clips and slide down"
Bill
NSW
"Good advice on your web page."
