"Read the oem pid"
Ice maker assy
Location Ref: 20
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Kevin
WA
"The ice maker unclips and unplug and is easy to replace"
Jason
WA
"Remove front cover. push front centre clip down and slide unit forward. unplug unit power harness. reverse to fit. very simple and quick."
David
QLD
"Clips in"
Peter
SA
"All you need is a screwdriver to unclip the middle top front of the ice tray then slide forward."
Glenn
NSW
"The cover on front of ice maker held by two clips - it will pull straight off with a little force. there is one phillips head screw to remove. then ice maker unclips from the top of freezer, unclip the electrical connection. then the reverse to install new one."
Caroline
QLD
"Part just slid into its spot"
Paul
WA
"Gently levered the ice tray facia forward from the top it unclips. flat head screwdriver used to push a plastic clip in and slide forward the icetray. unplug the cable. plug in new tray, push icetray back into place."
Terry
TAS
"Pull the whole ice tray assembly straight out towards you (takes a bit of a tug), unplug the assembly (the most difficult bit), then swap the front cover to the new assembly and reverse the steps to replace."
Ian
VIC
"Once i figured out to get the cover off (use a flat head screwdriver and prise off gently) the rest was easy. unplug ice maker - release one clip in the centre and then slide out."
