"The parts were perfect was easy to fix."
INLET VALVE 2WAY (COLD)
Location Ref: A15
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
Ian
SA
"Turn water off. remove machine top 2 screws at rear then slide to rear lift. remove hoses electrical connectors from valve assembly mark right left for re-connection. remove valve assembly 2 screws into bracket. fit new assembly repeat steps in reverse."
Wayne
QLD
"Turn off and disconnect the power. remove the top of the washing machine by removing the screws in the back and sliding back the top off the front lock pins. then simply disconnect the wires remove the hoses and unscrew the old valve assembly. reverse the above to reinstall the new unit. note make sure the wires are reconnected the same way they were removed."
Luke
NSW
"I have a basic understanding of w.ms and d.ws so fault finding was simple"
Garry
SA
"Remove top cover from washing machine. disconnect wiring and hoses from valve asembly and replace assembly. re-connect wiring and hoses and replace top cover."
Merv
QLD
"Part very easy to replace. remove top cover and metal plate. part easily visable"
David
SA
"Simple access at the rear of the unit - plug and play"
Andrew
SA
"Remove the top of the machine by removing the two bolts at the back then slide the top backwards and lift off. unscrew the cold water valves from the back then take the spring clamps off the pipes and remove pipes, then unplug the two valves off the wiring loom, then install in reverse."
Guy
NT
"2 screws for lid and 2 screws for valve. simple fix."
David
SA
"Make sure to switch off power and note which cables go where."
