"Using flat blade screwdriver stretch the cabinet gasket clamp, remove using phillips screwdriver, unscrew 2 screws holding the door lock, peel back the gasket, pull the door lock assembly from inside the cabinet through the gap between the cabinet gasket, pull door lock assembly from wiring connector, replace see p36 of service manual jordansmanuals.com"
SWITCH ASSY., DOOR
Location Ref: A100
Exploded diagrams, Schematics and other documents
Installation
Ross
NSW
"Remove front rubber boot seal spring loaded circlip, remove front rubber boot seal, unscrew and unplug door latch sensor, replace sensor reassemble"
Dale
NSW
"Remove the front door off the machine. remove spring and wire holding the rubber door seal in place. remove door seal rubber. unscrew door switch from front. reach in behind and pull switch out to unplug it. plug in new switch and reinstall everything."
Nicole
VIC
"I have not yet fit the part because it has not arrived"
Peter
WA
"Undo two screws affixing switch to front of machine then carefully remove spring-loaded wire holding door rubber seal in place. pull back rubber seal enough on lh side sufficient to gain access to rear of switch and wiring harness. prize old switch from wiring harness fit new switch ..... then everything in reverse of removal taking care to ensure rubber seal is perfectly clamped and seal is flat with no twists or lumps."
Sharon
SA
"Spring needs to be released. rubber seal loosened near door switch. door switch replaced."