VALVE, COLD INLET, 16 L/MIN

"Turn off water at tap and unscrew water hose from valve. remove two screws on top panel and hinge forward to remove. twist valve and pull up to remove. pull wires off noting polarity. remove blue seal and fit to new valve, push down into place, connect wires. refit top panel. reconnect hose to valve, turn water back on - done"

"Nil"

"Turn off and disconnect power. disconnect fill hose. unscrew the top panel. unclip the plastic valve locking mechanism. cold valve is blue. hot valve is red. make a note sketch of the wiring positions and disconnect the wires. lift out the old switch and fit the new one. assemble is the reverse of disassemble. note hot water valve can be swapped for cold water valve while waiting for parts to arrive to allow machine to be used."

"Unscrew inlet hose, remove electric connections mark where they go, remove old inlet valve and replace it with the new. replace elec. connections and inlet hose. job done. forgot to mention you have to remove control panel cover first - 3 small philip head screws."

"Easy fit unplug old one and slip the new one in"

"The part was fitted very easily."

"Self explanitory"

"Just be careful not to pinch the seals. place in square."

"Turn machine off at powerpoint. unscrew head of machine 3 screws. unplug problem intake in this case hot and refit. ensure you plug the connections correctly not unlike a speaker for a car. all done. just run hot only to test and adjust your water to get temps right."

"Remove lid, unscxrew top rear back panel, unclip and remove hinge instrument module to front, unclip elect tabs and gently remove cw valve by twist and lift.. remove rubber grommet from old valve and fit to nreplacement unit... reassemble in reverse. unbelievable - easy"