"Dont know - didnt do it"
ROD KIT, SUSPENSION (KIT OF 4)(INC. ITEM 20)
Location Ref: 1
Exploded diagrams, Schematics and other documents
Installation
David
QLD
"Remove top from washer tub and lift each out individually and replace 1 by 1. when finished re level so washing tub is level (dont worry about washing machine levelness)"
Tom
QLD
"Tip machine on 45 degree angle and do one at a time a helper is required"
John
WA
"Same way you take them out."
George
VIC
"When fitting the new rods its easier with two people as youll need to tip the washing machine on a 45 degree angle for the removal and installation of the new rod"
Bernard
QLD
"Very simple - remove top holding screws, replace 4 spring loaded rods, about 10 minutes"
Ken
QLD
"Fairly simple remove and replace"
Francis
QLD
"Tips on the fault repair list were accurate. in addition i had to re-level the machine."
John
QLD
"Disconnect power and water. remove two screws at rear and two at top front (under snap in ccovers). lift the top of the machine up and support. to remove old rod lift it up and remove top securing plastic and let rod drop. tilt machine to remove from underneath replace is reverse. if you have no assistant would recommend replacing one rod at a time"
David
NSW
"Phillips head screwdriver to remove the top cover and pliers to hold the spring while fitting to frame. you need to tilt the machine at 45 degrees to fit and remove the springs from the bottom. a second person would be helpful but not necessary."